Interior Wall Boards – Part I


Well, we’ve (mostly) completed plumbing, we’ve (nearly) completed electrical, now we’re onto installing the walls! It really is a relief to finally be working on something a little less technical.

First, we need to decide on a look for the interior. (That whole “wanting the house to look nice” thing.) We both really like the aesthetic of varnished wood, but didn’t want all the knots and spots you tend to see in pine. Pine is often used in tiny houses because of the cost and weight, but we really dislike the chaotic look. We considered painting the interior, but decided against it because we preferred a more natural appearance. So we knew we needed a wood species that looked really good. We looked around. We thought about milling hardwood like we did for our floor boards, but found that because of the way hardwoods are sold and processed, we would have had to buy boards that were twice as thick as we needed. This means we would have to plane the boards down, turning half of our investment into sawdust. So we began looking into high-grade hardwood plywood. At first we were hesitant about using plywood. We’ve read a lot about how plywoods tend to be made with heavy-duty adhesives that contain high amounts of urea-formaldehyde. Normally, because formaldehyde is natural and commonly found in in low levels in most building materials you just have to learn to live with it, but in such high concentrations in such a small space, we had to be careful. However, we found a type of birch plywood called PureBond Hardwood Plywood made by Columbia Forest Products that sold itself on using formaldehyde free adhesives and zero voc processing methods. After a little research, we decided to try it!


We both really like the look of birch (just see our flooring) so we bought a stack of ½ cabinet grade hardwood plywood. All 28 sheets of it! Afterwards, all we needed to do was decide on the board width. We looked around online at other tiny houses and decided we liked the look of wider boards. We determined that we could cut our boards into roughly 9” wide slats and leave ourselves with only half an inch left over. Talk about efficient! This took only a few hours of work. We also decided to add an extra dimension of texture to our walls by making a small horizontal groove at the top of each board to make it appear as if there was a small darkened space between each board. This created a strong dark line along each board that made the final look appear much more modern and clean. After that, we had our boards! Now we had to varnish them…


We decided to finish our wall boards with a simple zero voc furniture varnish from ECOS Paints. We sealed our floors with a very similar product from ECOS, and we were very happy with how easy it was to work with and how clean and good looking the final product looked, so we ordered a little bit more for our wall finishing.

We then made an assembly line for processing the boards. We would sand each board, varnish it, put it up to dry in the house (in our excellent holding racks made of leftover 2x4s stacked all over the house), wait til they dried, sanded the boards again, varnished again, and then repeat it all over again.

I must say, I did enjoy traversing through the boards while humming the Mission Impossible theme song as I tried to scale the boards to access and pile the dry ones in the back.

What made things even more complicated was that only half of them could fit in the house at one time to dry… which meant we ended up with two stacks of boards, one a step further along in the process than the other. Just to make things more confusing. You KNOW how much we love confusing.

We ended up with five separate layers of boards in the house, many carefully balanced across 2x4s as shown here.

Next we’ll be installing the boards, and finally we just might get to really work on the interior! Woohoo!